The controller can’t see the AC
An infrared controller works like a remote that never runs out of batteries. It sends a code, and the AC acts on it. Nothing comes back. ESPHome’s documentation puts it simply: IR is one way, so the controller assumes the AC is in the last state it requested.
That assumption breaks the moment something else changes the AC. The usual culprits:
- Someone uses the original remote
- Someone presses the buttons on a window or portable unit
- A power cut resets the AC
- The beam was blocked when the controller sent its code
What each maker says
Mysa tells owners to control the AC only through Mysa after pairing, because the original remote causes sync issues. Cielo’s advice is to point the original remote at the Breez rather than the AC, and it adds a manual Sync AC State option in the app. Sensibo notes that on window and portable units it sends relative commands, so the unit’s own buttons make it drift, and the fix is to match the unit to the app once.
Four habits that keep it in sync
- Put the original remote in a drawer after fitting
- Use the app, the controller’s own buttons or voice
- After a power cut, check the app and resync if it disagrees
- Keep the line between controller and AC clear of curtains and shelves
When it keeps happening
If your household can’t give up the remote, a two-way option is better. The maker’s Wi-Fi module reads the AC’s real state, so the app is always right. We fit those for Daikin, Mitsubishi Electric, LG and Panasonic, and set up the built-in Wi-Fi on many Samsung, Gree, Hisense and Midea units.